[andrew phillips]

I want to order a spare crush gasket for the oil screen access for my Superior IO-360. Anybody know which size it is? I don't want to remove the cowl to measure before I order if possible.

 

[JHines]

check this thread:

http://www.vansairforce.com/community/showthread.php?p=222246

 

[az_gila]

Lots of good info...

I want to order a spare crush gasket for the oil screen access for my Superior IO-360. Anybody know which size it is? I don't want to remove the cowl to measure before I order if possible.

...in this thread, including the part number you need....

http://www.vansairforce.com/community/showthread.php?t=29848&highlight=oil+screen+washer

 

[hevansrv7a]

not to be torqued

I want to order a spare crush gasket for the oil screen access for my Superior IO-360. Anybody know which size it is? I don't want to remove the cowl to measure before I order if possible.

I see the size issue is handled. Check your manual carefully and I think you will find that the specification for that is given in degrees of turn after finger-tight rather than foot pound or inches. Just a little extra hint. Order a few - you'll want to check it on each oil change.

 

[mikehoover]

I want to order a spare crush gasket for the oil screen access for my Superior IO-360. Anybody know which size it is? I don't want to remove the cowl to measure before I order if possible.

Andrew,

perhaps these links might help you:

http://aclog.com/blog/?p=13

http://www.tcmlink.com/pdf2/SB96-7C.pdf

Mike