I didn't want to post this in the existing thread since it's really not the same issue...
I just bought a CP-214 and I've never used one. I have no idea how to set this thing up or whether I even have the right dies to use with it.
I have an assortment of Cleaveland flat and cupped rivet sets (for squeezers) and dimple dies. The only ones that come in pairs are the dimple dies - I assume I can use these with the CP-214?
What about squeezing rivets? Do I just use an arbitrary pair of the flat sets - one that gets the spacing close and then shim as needed?
Very confrused.
Below is what I've got:
I just bought a CP-214 and I've never used one. I have no idea how to set this thing up or whether I even have the right dies to use with it.
I have an assortment of Cleaveland flat and cupped rivet sets (for squeezers) and dimple dies. The only ones that come in pairs are the dimple dies - I assume I can use these with the CP-214?
What about squeezing rivets? Do I just use an arbitrary pair of the flat sets - one that gets the spacing close and then shim as needed?
Very confrused.
Below is what I've got:
Last edited: