Fellow builders.
I am seeking first hand experience with per plans installation of the horizontal bottom cowl hinges on an RV-7A of 9A (don't know if 6A's are the same).
It appears from the drawings that it might be more than a little difficult to remove and install the hinge pins due to the fact that the exhaust tubes are right it the way.
For those who have built theirs per plans is there an issue? Would you repeat this installation again?
Any input would be appreciated.
Paul
RV-7A finishing kit
I am seeking first hand experience with per plans installation of the horizontal bottom cowl hinges on an RV-7A of 9A (don't know if 6A's are the same).
It appears from the drawings that it might be more than a little difficult to remove and install the hinge pins due to the fact that the exhaust tubes are right it the way.
For those who have built theirs per plans is there an issue? Would you repeat this installation again?
Any input would be appreciated.
Paul
RV-7A finishing kit