Flying C
Member
Ok..this maybe a very obvious answer to this question, but I sure can't seen to find it. I am getting ready to countersink the spar in order to attached the K1000-3 platenut to the aft side of the spar. This is an attachment point of one of the Z brackets. My question is, how do you get your countersink tool into place? The cage on my countersink tool is a little too wide so I can't get the countersink bit into place for the two outside holes. See attached picture.
I have looked on Avery's website to see if there was a special countersink tool, but I didn't see one. How has everyone else been doing this?
Thanks,
Jake
I have looked on Avery's website to see if there was a special countersink tool, but I didn't see one. How has everyone else been doing this?
Thanks,
Jake