Hey gang,
I'm ready to counter sink the many small #40 holes in the wing spar to accept the skin #40 dimples. A bunch of them.
Did you guys sink the counter sink just enough to make a 3/32 rivet head flush? Or did you go deeper until a test dimple sits totally inside the counter sink? (This might be too deep). Or somewhere inbetween.
I would like to know what diameter your counter sink is that accepts the #40 dimple.
Thanks gang. Ed
I'm ready to counter sink the many small #40 holes in the wing spar to accept the skin #40 dimples. A bunch of them.
Did you guys sink the counter sink just enough to make a 3/32 rivet head flush? Or did you go deeper until a test dimple sits totally inside the counter sink? (This might be too deep). Or somewhere inbetween.
I would like to know what diameter your counter sink is that accepts the #40 dimple.
Thanks gang. Ed