yankee-flyer
Well Known Member
I've seen posting for forming the cooler door gasket on the firewall instead of the door. After test-fitting the parts, I'm not sure I see any advantage either way. Big problem is that the door can twist/flex. It looks like it would actually be easier to form a uniform bead on the door and then put it in place, Pros/cons fron those whom have done it?
PS-- Called Van's today about the "Extra" piece in the FF kit that looks like a shim to go between the door and the hinge(FF-1205D??) but isn't shown on the plans. Answer was that that part is "outmoded" and shouldn't be used.
THANKS
Wayne 120241
PS-- Called Van's today about the "Extra" piece in the FF kit that looks like a shim to go between the door and the hinge(FF-1205D??) but isn't shown on the plans. Answer was that that part is "outmoded" and shouldn't be used.
THANKS
Wayne 120241