Hi all
For our national regulatory acceptance proceudre I need to indicate nominal values and tolerances of the control surfaces of the RV-12. To my surprise I can't find any indication neither in the KAI, nor in the PAP from Van's.
I measured all deflection angles on my plane and would like to verify if they are within limits.
Any help on this or pointers are greatly appreciated.
If you like, post the measurements of your control surfaces here in this thread, so that I can get a feel if my values are among yours.
Thank you very much.
Chris
For our national regulatory acceptance proceudre I need to indicate nominal values and tolerances of the control surfaces of the RV-12. To my surprise I can't find any indication neither in the KAI, nor in the PAP from Van's.
I measured all deflection angles on my plane and would like to verify if they are within limits.
Any help on this or pointers are greatly appreciated.
If you like, post the measurements of your control surfaces here in this thread, so that I can get a feel if my values are among yours.
Thank you very much.
Chris
