swisseagle
Well Known Member
Hello builders
One question about the controll stick assembly, RV-7A, DWG 38 bottom left
Which is supposed to rotate?
The WD-611 (controll stick right/left weldment) around the bushing
OR
the bushing around the AN3-27 screw?
The nut is a castelated nut, so I think you do not tighten to std. torque.
This would mean that the bushing is rotating around the screw and the
bushing which is anyway a bit tight in the WD-611 (disorted after welding I
think), does not rotate.
Does this seams right?
Thanks for your input, regards,
Dominik
One question about the controll stick assembly, RV-7A, DWG 38 bottom left
Which is supposed to rotate?
The WD-611 (controll stick right/left weldment) around the bushing
OR
the bushing around the AN3-27 screw?
The nut is a castelated nut, so I think you do not tighten to std. torque.
This would mean that the bushing is rotating around the screw and the
bushing which is anyway a bit tight in the WD-611 (disorted after welding I
think), does not rotate.
Does this seams right?
Thanks for your input, regards,
Dominik