lokobuff
Member
Ok, so it says: "Using the dimensions given in Sec D-D, mark the hole locations on the forward side of the forward flange of HS-405. These holes attach..."
I've marked the top hole, and top hole only (2.5 times rivet diameter from edge of flange), but am not sure where to mark the next three. I see the dimensions given in Sec D-D, but those are listed as a distance away from the spar reinforcement pieces. I don't feel like I could mark an accurate hole in HS-405 based on that. Thoughts?
loko
I've marked the top hole, and top hole only (2.5 times rivet diameter from edge of flange), but am not sure where to mark the next three. I see the dimensions given in Sec D-D, but those are listed as a distance away from the spar reinforcement pieces. I don't feel like I could mark an accurate hole in HS-405 based on that. Thoughts?
loko