boom3
Well Known Member
I have read the threads I could find about the wing conduits and am planning on using the Home Depot .062 thin walled conduits. Hopefully I am planning ahead for everything I can think of.
Landing Lights
Nav Lights
Strobes
Heated pitot with AOA
Whatever antennas you would or could put in the tips. (Planning for IFR platform)
My plan was to use one of the conduits for lighting and the other for antenna cables. I plan on opening up the rear tooling hole so I can maximize the distance from the lighting conduit. As for the heated pitot and AOA I was just going to open up the tooling hole next to the pitot line to 7/16? and use grommets. I figure this wiring would be pretty easy to run open since it is near the inspections plates.
Any suggestions, comments, criticism? Thanks!
Landing Lights
Nav Lights
Strobes
Heated pitot with AOA
Whatever antennas you would or could put in the tips. (Planning for IFR platform)
My plan was to use one of the conduits for lighting and the other for antenna cables. I plan on opening up the rear tooling hole so I can maximize the distance from the lighting conduit. As for the heated pitot and AOA I was just going to open up the tooling hole next to the pitot line to 7/16? and use grommets. I figure this wiring would be pretty easy to run open since it is near the inspections plates.
Any suggestions, comments, criticism? Thanks!