[Kato's 8]

Hello!
I was looking through the panel pics on site and didnt see much in regards to rear side support-eg angle brackets etc. I am using standard alum angle to mount xponder and radio trays to the panel. They are side by side in panel at bottom and will be riviting them in place. Question is, How are similar installs being supported on the other end? Just looking for ideas here and maybe some pics.
Thanks everyone!

Bill

 

[ChrisMallory]

I attached the back of the stack to the F-802N like this.

But next time I have it all out, I'll change it to this

You can see the rest of my writeup here:
http://www.kit-plane-advice.com/electric-system-lessons.html#Radio_Trays

 

[ambrosesquadronca]

Support Bracket

Made a bracket from some aluminum angle.

 

[SHIPCHIEF]

I ran a brace from the back of the radio trays, up to the panel.
I can remove the panel screws and set the panel down enough to work behind it from the top. Sure beats trying to squirm in underneath with the spar & control stick.