R

rv6ehguy

Well Known Member
Patron
Good day folks,
I am about to install my CHT probes on my engine. They are the type that screw into the cylinder boss. I was wondering if it’s prudent to put a little antisieze compound on the screws? Would I use the same antisieze for the spark plugs? Thanks for your time.
John Van Lieshout
RV6A QB 85%
AeroSport Power IO-375 M1S 195hp
Garmin G3X Touch 2 screen suite
(Looking for a prop)
 
Antisieze

You want heat transfer from cylinder to the CHT-probe and antisieze.
I use the copperbased antisieze for sparkplugs.
It is also possible to use thermal transfer compound from electronics shop.
Just be sure it has the correct temperature rating.

Good luck
 
You must log in or register to reply here.