[Vlad]

We are organizing wiring runs behind center section and slowly moving forward learning on the way. The vertical bunch of wires (cockpit lights, ELT etc) - how it goes up? Between pushrods or around left one? Sorry no pictures.

Also how much loop is needed for comm wire? The same location under center section.

 

[rvbuilder2002]

We are organizing wiring runs behind center section and slowly moving forward learning on the way. The vertical bunch of wires (cockpit lights, ELT etc) - how it goes up? Between pushrods or around left one? Sorry no pictures.

Also how much loop is needed for comm wire? The same location under center section.

There is a drawing (don't remember which one) that shows the wire bundle going vertical between the 2 push/pull tubes, and then up through the snap bushing in the middle of the center section channel. It is shown tied off with a single tie wrap looped through both the holes the Push/Pull tubes pass through.

 

[Vlad]

Thank you Scott will look into it today.