My center section F-704A and F have empty holes on each out-board side (about 3-4); all the other holes have #5 (or 6) rivets in them installed by the factory.
I asked Van's about this and they said they are to be drilled out for the landing gear mounts... but I'm building a tail dragger (no gear at the center section). When I pointed this out to Van's they said just use shorter bolts... ?
What have you other taildraggers been doing here?
Thanks
Dave C
RV 7
I asked Van's about this and they said they are to be drilled out for the landing gear mounts... but I'm building a tail dragger (no gear at the center section). When I pointed this out to Van's they said just use shorter bolts... ?
What have you other taildraggers been doing here?
Thanks
Dave C
RV 7