[yankee-flyer]

has anyone been able to find the adaptor fittings and hoses (TS-400) sjhown on the Carbmate site? I'
ve checked the locations listed-- aircraft Spruce and Lockwood-- with no luck.

Thanks
\
Wayne 120241

 

[Jetguy]

Tubing

Try http://www.leadingedge-airfoils.com/ they sell this product, ask for tech support. 1-262-763-4087

John
RV12 N1212K

 

[Tony_T]

Additional info

There is additional information on the carbmate adapter kit in this thread:
http://www.vansairforce.com/community/showthread.php?t=59287&highlight=carbmate+adapter

Tony

 

[jte65]

Carbmate

I used the Carbmate and basically followed the same setup as Tony (after seeing Tony's pictures), although I used nylon barbed fittings instead. Don't have the actual sizes handy but I was able to get the fittings for a few dollars. The carbmate hoses fit nicely on the barbed end and then I selected a threaded end that would fit inside the hoses on the Rotax. I will try and post a picture of my setup later.

Jeff

 

[Mark Henderson]

I made adapters following the advice of Tony. It took all of 5 minutes using a file and chucking the brass fittings in a drill press. Skip the expensive kit and go to your nearest Ace hardware store.