I have a canopy from Todd's and have trimmed it until it is in contact with the roll bar, how ever I still have quite a gap on the sides between the forward upper skin on both sides near the roll bar and not much over lap of the slider frame,
I was planning to go the Sika route, but if I do not have enough over lap I could take the spacers out and gain some more trimming in the front to bring the sides down
so my question is, should I trim more from the very front of the canopy to bring it forward and down or just make the big cut now? if I make the big cut will I have enough area for the Sika bond?
hard to see in this pic but the canopy is sitting down nicely on the front skin
I was planning to go the Sika route, but if I do not have enough over lap I could take the spacers out and gain some more trimming in the front to bring the sides down
so my question is, should I trim more from the very front of the canopy to bring it forward and down or just make the big cut now? if I make the big cut will I have enough area for the Sika bond?
![IMG00144.jpg](/community/proxy.php?image=http%3A%2F%2Fimg.photobucket.com%2Falbums%2Fv319%2Fchessiepup%2FN258RE%2FIMG00144.jpg&hash=0e17a9af845d9e6bb4eb15af9df0ab1a)
hard to see in this pic but the canopy is sitting down nicely on the front skin
![IMG00142.jpg](/community/proxy.php?image=http%3A%2F%2Fimg.photobucket.com%2Falbums%2Fv319%2Fchessiepup%2FN258RE%2FIMG00142.jpg&hash=5070fd23ee09bcb7bd5c057ff656d57d)