rcarsey
Well Known Member
ridiculous question time. I'm working on the canopy rib assembly. Section 29, Page 6, Step 6...
Step 6 says to final drill with #17 (.173") (i only have a #16 (.177")..cuz #17 wasn''t listed as a tool needed in the revised chapter 3).. Ok #16 is slightly bigger.. close enough for what we're trying to accomplish here i guess.
it goes on to say .. "..then dimple the nutplate screw holes".
what dimple die to i want to use for a #17 hole (.177")? The #8 (.16") dimple die? I'm assuming so..but just making sure there isnt a die i dont have.
Step 6 says to final drill with #17 (.173") (i only have a #16 (.177")..cuz #17 wasn''t listed as a tool needed in the revised chapter 3).. Ok #16 is slightly bigger.. close enough for what we're trying to accomplish here i guess.
it goes on to say .. "..then dimple the nutplate screw holes".
what dimple die to i want to use for a #17 hole (.177")? The #8 (.16") dimple die? I'm assuming so..but just making sure there isnt a die i dont have.