denbobp Well Known Member Mar 8, 2012 #1 It appears that AN 4 bolt can not slide through the control stick brass bushings without reaming the bushing. Has anybody run across this scenario. Thanks
It appears that AN 4 bolt can not slide through the control stick brass bushings without reaming the bushing. Has anybody run across this scenario. Thanks
S SHIPCHIEF Well Known Member Mar 8, 2012 #2 IIRC; All the brass tube bushings required running a drill or a reamer thru to allow the bolt to fit.
IIRC; All the brass tube bushings required running a drill or a reamer thru to allow the bolt to fit.
pazmanyflyer Well Known Member Mar 8, 2012 #3 SHIPCHIEF said: IIRC; All the brass tube bushings required running a drill or a reamer thru to allow the bolt to fit. Click to expand... This is correct. When working on -7 aileron bell crank brass bushings it states that this is also typical for the bushings at the controls.
SHIPCHIEF said: IIRC; All the brass tube bushings required running a drill or a reamer thru to allow the bolt to fit. Click to expand... This is correct. When working on -7 aileron bell crank brass bushings it states that this is also typical for the bushings at the controls.