vmirv8bldr
Well Known Member
Last night I ran through a dress rehersal of lining up the trays to drill the angle which will eventually hold my radio stack to the panel. I did a search and read the mthods described. I chose the "duct tape" method and used BIll's idea with the popsicle sticks. It worked great, but I have a problem.
In order to spread the cost out, I have some, but not all of my radio gear. Here's the stack:
PMA9000
GNS-430
SL-40
GTX-330
I have everything but the SL-40, so I can easily align them. My question is if anyone has a similar stack, I would like to know about how much the SL-40 tray needs to be set in reference to the GNS-430 and GTX-330 trays so the faceplates line up.
Any one have a setup they can measure or send photos?
Thanks
In order to spread the cost out, I have some, but not all of my radio gear. Here's the stack:
PMA9000
GNS-430
SL-40
GTX-330
I have everything but the SL-40, so I can easily align them. My question is if anyone has a similar stack, I would like to know about how much the SL-40 tray needs to be set in reference to the GNS-430 and GTX-330 trays so the faceplates line up.
Any one have a setup they can measure or send photos?
Thanks