Simon Hitchen
Well Known Member
Well, surprises still happen this far into the build. I managed to snap a 6-32 tap this morning while tapping a hole in the longeron for the rear inspection plate.
A quick attempt to drill into the tap failed and wandered, so that was quickly abandoned.
Any thoughts on the best way to remove this would be greatly appreciated. Once out I can enlarge to 8-32 if needed.
Many thanks
A quick attempt to drill into the tap failed and wandered, so that was quickly abandoned.
Any thoughts on the best way to remove this would be greatly appreciated. Once out I can enlarge to 8-32 if needed.
Many thanks