I'm up to the point of the tailcone construction on my RV-12 and the instructions call for "breaking" the edge of the sheets. I've experimented with both the modified vice grips and the round plastic thing with rollers. Both make a wavy mess in thin material like the .020 of the tailcone.
How has everyone done this with good success? I'd hate to ruin this part of the kit after everything else fits like a glove.
Thanks in advance,
Mitch Garner
RV-4 flying
PL-4 flying
RV-12 under construction
How has everyone done this with good success? I'd hate to ruin this part of the kit after everything else fits like a glove.
Thanks in advance,
Mitch Garner
RV-4 flying
PL-4 flying
RV-12 under construction