S smokenjoe50 Active Member Aug 11, 2009 #1 How did you guys make the bend in the brake line from the caliper? I am talking about the 360 degree bend. Did you use a bender or just form it by hand?
How did you guys make the bend in the brake line from the caliper? I am talking about the 360 degree bend. Did you use a bender or just form it by hand?
J JBPILOT Well Known Member Aug 11, 2009 #2 By Hand The tubing bends very easy. Just slowly shape it the way you want it. No serious bends, just slow sweeping bends. John Bender
By Hand The tubing bends very easy. Just slowly shape it the way you want it. No serious bends, just slow sweeping bends. John Bender
MartySantic Well Known Member Aug 11, 2009 #3 Used one of the cheap spring benders and finished it by bending the tubing by hand. Opened it up a bit, cut it to size and flared the end.
Used one of the cheap spring benders and finished it by bending the tubing by hand. Opened it up a bit, cut it to size and flared the end.
S smokenjoe50 Active Member Aug 12, 2009 #4 Thanks. I was surprised vans did not give us one of those drawings like the fuel line.