[geoffwhatnot]

I'm trying to figure out what the intended way is to route the Bonaco 45 degree angled fuel vent lines for a 9A. Specifically, struggling to understand how to route it under or over the rudder cable and into the fitting on the F-902 bulkhead. Any pictures or descriptions appreciated.

 

[PaulR]

Pictures

Geoffry,
If you don't get any soon, I'll try to take some next time I'm in the shop. I do remember that the straight fitting goes to the vent(bulkhead fitting) on the bottom of the fuse on mine though. On mine it follows where Van would have you put the solid aluminum line.

 

[Bruce]

Go with the strait fitting on one end and a
90 on the other end. It will work better if
you use a 90 bulkhead to your tank vent,
instead of the 45 that Van's recommends.

I set it up this way and if you talk with
Brett he should have the lengths.
He has them for the 7 for sure.

Hope this helps.
Boomer