RudiGreyling
Well Known Member
Just a quick question,
I'm busy with the flaps and I need to bend FL-706B to 6.3 degrees.
I tried putting in the bench vice, on the bend line, and pulling on it with my hands to no avail... How do you guys bend it with only garage tools available?
How do you make sure it ends up to 6.3 degrees? mark it out on a piece of paper and continue trial and error until it is right?
Thanks in advance...
Regards
Rudi
I'm busy with the flaps and I need to bend FL-706B to 6.3 degrees.
I tried putting in the bench vice, on the bend line, and pulling on it with my hands to no avail... How do you guys bend it with only garage tools available?
How do you make sure it ends up to 6.3 degrees? mark it out on a piece of paper and continue trial and error until it is right?
Thanks in advance...
Regards
Rudi
![fl706b1.jpg](/community/proxy.php?image=http%3A%2F%2Fwww.freepgs.com%2Fflyboy%2Fpictures%2Frv_forum%2Ffl706b1.jpg&hash=7c0664545b346b1bc6642e8afa4c819a)
![fl706b2.jpg](/community/proxy.php?image=http%3A%2F%2Fwww.freepgs.com%2Fflyboy%2Fpictures%2Frv_forum%2Ffl706b2.jpg&hash=7c12c640207dd5276c2e75ffde158df1)