Jamie
Well Known Member
Hey All:
I've got all of my baffle bulkheads into place and I'm trying to trim them down to match the contour of the top cowl. I've used the "washer on a sharpie" trick to mark the contour but that's really only doable on the back bulkhead by reaching through the oil door. I have the side bulkheads on #3 and #4 cylinders but I can't reach them with a pen. Is there some trick to this I'm not seeing?
I just did a search and found a paper clip method that I'm going to try tonight. Anyone else have any clever ideas?
I've got all of my baffle bulkheads into place and I'm trying to trim them down to match the contour of the top cowl. I've used the "washer on a sharpie" trick to mark the contour but that's really only doable on the back bulkhead by reaching through the oil door. I have the side bulkheads on #3 and #4 cylinders but I can't reach them with a pen. Is there some trick to this I'm not seeing?
I just did a search and found a paper clip method that I'm going to try tonight. Anyone else have any clever ideas?