Hi folks,
I have to penetrate my rear baffle for a couple of wires (to LSE coils) and for the AFP purge valve control. I need to line the holes with something for seal and anti-chaff. I don't really know how hot the baffles get. I am talking about two or three 1/4 to 3/8 holes. Should I line these with rubber grommets, snap bushings or something else? Rubber grommets would be the best solution except I was worrying about them melting. I searched this a couple of ways and couldn't come up with an answer. Thoughts?
Michael Wynn
RV 8 FWF
San Ramon, CA
I have to penetrate my rear baffle for a couple of wires (to LSE coils) and for the AFP purge valve control. I need to line the holes with something for seal and anti-chaff. I don't really know how hot the baffles get. I am talking about two or three 1/4 to 3/8 holes. Should I line these with rubber grommets, snap bushings or something else? Rubber grommets would be the best solution except I was worrying about them melting. I searched this a couple of ways and couldn't come up with an answer. Thoughts?
Michael Wynn
RV 8 FWF
San Ramon, CA