Hi
I am getting towards finishing the metal work involved in making my RV7 baffles. In looking to remove any non useful material, I am wondering whether the material, that is part of the horizontal(ish) baffle material of Cyl 1 and 2, behind the flywheel can be removed. This is the material that is the flywheel side of the front vertical baffles. These “overshoots” seem to be serving no useful purpose or am I missing something? It seems they will be in the low pressure air volume. Your experience/thoughts/knowledge would be much appreciated. Unfortunately I am not able to attach a picture which explains the area referred to better.
Regards
David Robbins RV7 Photo now added I Hope
www.flickr.com/photos/155370574@N02/
I am getting towards finishing the metal work involved in making my RV7 baffles. In looking to remove any non useful material, I am wondering whether the material, that is part of the horizontal(ish) baffle material of Cyl 1 and 2, behind the flywheel can be removed. This is the material that is the flywheel side of the front vertical baffles. These “overshoots” seem to be serving no useful purpose or am I missing something? It seems they will be in the low pressure air volume. Your experience/thoughts/knowledge would be much appreciated. Unfortunately I am not able to attach a picture which explains the area referred to better.
Regards
David Robbins RV7 Photo now added I Hope
www.flickr.com/photos/155370574@N02/
Last edited: