RV8A_FLYBOY
Member
Here is the back rivet work bench that I built - note it has rubber pads mounted to the bottom of the legs.
![ricksrv8a009wn4.jpg](/community/proxy.php?image=http%3A%2F%2Fhttp%3A%2F%2Fimg166.imageshack.us%2Fimg166%2F5829%2Fricksrv8a009wn4.jpg&hash=27b9d4652d977629592a659ef40d3c90)
![my.php](/community/proxy.php?image=http%3A%2F%2Fimg166.imageshack.us%2Fmy.php%3Fimage%3Dricksrv8a009wn4.jpg&hash=1619d035452921113ab3e3809083c823)
Last edited:
Here is the back rivet work bench that I built - note it has rubber pads mounted to the bottom of the legs.
O.K., now add lines to the table top, extending along each side of the plate.
You will end up with a big # looking setup.
Now when you are riveting, you can visualize where the plate is.