[N64GH]

Hopefully a simple question. I have tried searching past posts but no luck.

RV6 main gear axle unt cotter pin. What the heck size is it? AN#, or something so I can get the correct size?

I an not sure why this simple peace of hardware is so hard for me to figure out but it is .

 

[wcalvert]

For the -7, drawing C2 Section A-A shows it as an MS24665-359 Cotter Pin...

 

[Plummit]

Hopefully a simple question. I have tried searching past posts but no luck.

RV6 main gear axle unt cotter pin. What the heck size is it? AN#, or something so I can get the correct size?

I an not sure why this simple peace of hardware is so hard for me to figure out but it is .

Mike, if they are the same at the -10 I have a slew of them. Let me know and I'll get a few of them to you.

-Marc

 

[gasman]

Hopefully a simple question. I have tried searching past posts but no luck.

RV6 main gear axle unt cotter pin. What the heck size is it? AN#, or something so I can get the correct size?

I an not sure why this simple peace of hardware is so hard for me to figure out but it is .

If you did not get plans when you purchased your RV6,A, you need to order this... https://store.vansaircraft.com/rv-6-6a-usb-flash-drive-plans-manual-fd-plans-rv-6-6a.html

 

[N64GH]

Thanks

Not sure why however cotter pins baffle me, no explanation. Thought a quick simple question would be no big.

 

[N64GH]

Thanks

That should get me what I need.

 

[N64GH]

Thanks but I am driving distance to ACS just needed a small push in the correct direction. However if you are at CCB, that is much closer than ACS��