[BigJohn]

The other day I ran the DSAP procedures on the autopilot. All went well, but there were a couple of things that raised my eybrows. Some of the autopilot parameters that I found pre-set in the units did not match the default values as pubished in the D180 manual. I'm wondering if they changed some default values in the 5.4 upgrade, or if some of these values came from the Van's lock file, and that's why they don't match the manual?

Anybody else see this, or know the answer?

 

[Jetguy]

Dynon has revised their Manual!

With the 5.4 software update Dynon updated their Installation Manual with some new Information on new Settings they have added to the pitch Servo. Start at the bottom of page 8-18. Did you download the new Manual from the Dynon Web site? If not try here.
http://www.dynonavionics.com/docs/support_documentation.html

John
RV12 N1212K

 

[BigJohn]

John,

Thank you very much! Never gave it a thought that the manual might have been revised. Just sent the links off to PostNet to print and bind the new versions. When I get them I'll run the procedure again.

John P.