This is a picture of my cooling air ramp with a piece of plywood holding it at the
1 7/16" radius shown on page 36 of the plans.Obviously this radius does not put it in a position for riveting to the firewall. Does the builder use that bend to "start" the bend and proceed to make a bend that will put the flange flat against the firewall for riveting? Is there a dimension that the flange should fall on that I am missing? Thanks, Rich.
http://i62.tinypic.com/2rx8dna.jpg
1 7/16" radius shown on page 36 of the plans.Obviously this radius does not put it in a position for riveting to the firewall. Does the builder use that bend to "start" the bend and proceed to make a bend that will put the flange flat against the firewall for riveting? Is there a dimension that the flange should fall on that I am missing? Thanks, Rich.
http://i62.tinypic.com/2rx8dna.jpg
