alpinelakespilot2000
Well Known Member
Can anyone tell me what the appropriate cotter pin diameter is for AN3, AN4, AN5, and AN6 bolts respectively? I assume (perhaps incorrectly) that I should use the largest diameter cotter pin that will fit through the drilled hole on the bolt (?).
Here's the page from Spruce that shows the possibilities.
http://www.aircraftspruce.com/catalog/hapages/cotterpins.php
Thanks.
Here's the page from Spruce that shows the possibilities.
http://www.aircraftspruce.com/catalog/hapages/cotterpins.php
Thanks.