fl-mike Well Known Member Jan 11, 2021 #1 Broke my #40 pilot. I like them, smoother cutting, but they can "pull" material up if you aren't careful, resulting in a too-deep countersink.
Broke my #40 pilot. I like them, smoother cutting, but they can "pull" material up if you aren't careful, resulting in a too-deep countersink.
I iwannarv Well Known Member Jan 11, 2021 #2 Is this what you're after? Says deburring bit, but its a 100 degree c/s bit. I use primarily for deburring, but if I need it to c/s, it works well. https://www.cleavelandtool.com/collections/drilling-and-deburring/products/3-hex-deburring-tool?variant=18378229153854
Is this what you're after? Says deburring bit, but its a 100 degree c/s bit. I use primarily for deburring, but if I need it to c/s, it works well. https://www.cleavelandtool.com/collections/drilling-and-deburring/products/3-hex-deburring-tool?variant=18378229153854
wirejock Well Known Member Jan 11, 2021 #3 Single flute This is what you seek. https://www.cleavelandtool.com/coll...g/products/single-flute-countersink-cutter-40 I quit using them because the pilot breaks easier. Plus they cost more.
Single flute This is what you seek. https://www.cleavelandtool.com/coll...g/products/single-flute-countersink-cutter-40 I quit using them because the pilot breaks easier. Plus they cost more.
fl-mike Well Known Member Jan 11, 2021 #4 wirejock said: This is what you seek. https://www.cleavelandtool.com/coll...g/products/single-flute-countersink-cutter-40 I quit using them because the pilot breaks easier. Plus they cost more. Click to expand... Thanks Larry. I couldn't find any whey I looked a while back. Yes, they are more fragile!
wirejock said: This is what you seek. https://www.cleavelandtool.com/coll...g/products/single-flute-countersink-cutter-40 I quit using them because the pilot breaks easier. Plus they cost more. Click to expand... Thanks Larry. I couldn't find any whey I looked a while back. Yes, they are more fragile!
