Hi.
We're about to start trimming the cowlings and baffling. On dwg 45 it says to use 1/8" by the top of the spinner and 1/8"-3/16" by the bottom edge.
I assume this is measurements for Vans std rubber mounts.
In Vans FF-kit which I bought this fall, they sent me Lord mounts and that was fine with me ofcourse, but I'm wondering about future sag?
Is it any less (or more for that matter) sag with the Lord mounts compared to the rubber mounts Vans used to have in their FF-kit?
Schould I adjust the measurements called out for at the dwg or use the same?
Thanks!
We're about to start trimming the cowlings and baffling. On dwg 45 it says to use 1/8" by the top of the spinner and 1/8"-3/16" by the bottom edge.
I assume this is measurements for Vans std rubber mounts.
In Vans FF-kit which I bought this fall, they sent me Lord mounts and that was fine with me ofcourse, but I'm wondering about future sag?
Is it any less (or more for that matter) sag with the Lord mounts compared to the rubber mounts Vans used to have in their FF-kit?
Schould I adjust the measurements called out for at the dwg or use the same?
Thanks!
