So my beautiful but very expensive Andair fuel valve arrived from Van's yesterday.
The AN ports are aimed sideway and I would like to rotate them 90° so they point down. The four little screws are not attached and the fittings wiggle a bit but resists gentle efforts to remove them.
Am I correct in assuming that the resistance I feel is an internal 'O' ring and I just need to pull harder?
I'm very reluctant to use any undue force as this valve was sooooo expensive. (although $25 cheaper at Van's compared to AS)
The AN ports are aimed sideway and I would like to rotate them 90° so they point down. The four little screws are not attached and the fittings wiggle a bit but resists gentle efforts to remove them.
Am I correct in assuming that the resistance I feel is an internal 'O' ring and I just need to pull harder?
I'm very reluctant to use any undue force as this valve was sooooo expensive. (although $25 cheaper at Van's compared to AS)
![valve.jpg](/community/proxy.php?image=http%3A%2F%2Fmyplace.frontier.com%2F%7Etokosha%2Frv7%2Fvaf%2Fvalve.jpg&hash=583739e58d81f325ab286f7485d9b1eb)
Last edited: