BSwayze
Well Known Member
The installation of my Andair Fuel pump assembly is giving me fits. After fiddling and working on this for way too long, I reached the big moment to start putting it all together only to find out my center cover, F-782C, doesn't fit between the two center floor stiffener ribs when I have the brackets and plate attached. I have posted a more thorough discussion and pictures on my web log here:
May 2, 2010 entry
and here:
May 3, 2010 entry
The problem, as I see it, is that my floor stiffeners are too close together causing my center F-782C cover to curve and warp. It's even worse when I try to install the pump assembly and bracket. Back about a year ago when I drilled them to the bottom floor skin, I drew a centerline down each stiffener and drilled them to the floor. How I wish I had known how critical the separation distance is between these floor stiffeners. A short note in the plans on Vans part would have saved me this mess. Look at these pictures, and you'll see what I'm up against:
I put a straightedge across it, shown below, to show just how bad it is.
I don't know what I'm going to do. I'm considering drilling out several dozen rivets and removing these floor stiffeners, and replacing them with new ones that are separated a bit more. It's a job I shudder to seriously consider, but what other option do I have? Has anyone else run into this? What did you do?
Is anyone else installing an andair system, that can share their experiences?
Thank you for any comments or help.
May 2, 2010 entry
and here:
May 3, 2010 entry
The problem, as I see it, is that my floor stiffeners are too close together causing my center F-782C cover to curve and warp. It's even worse when I try to install the pump assembly and bracket. Back about a year ago when I drilled them to the bottom floor skin, I drew a centerline down each stiffener and drilled them to the floor. How I wish I had known how critical the separation distance is between these floor stiffeners. A short note in the plans on Vans part would have saved me this mess. Look at these pictures, and you'll see what I'm up against:
I put a straightedge across it, shown below, to show just how bad it is.
I don't know what I'm going to do. I'm considering drilling out several dozen rivets and removing these floor stiffeners, and replacing them with new ones that are separated a bit more. It's a job I shudder to seriously consider, but what other option do I have? Has anyone else run into this? What did you do?
Is anyone else installing an andair system, that can share their experiences?
Thank you for any comments or help.