[Doug94]

If you have installed an aluminum spinner, how/have you drilled for the s603 front spinner bulkhead. There is a large gap between my S603 and the side of the spinner - should I ignore and just attach to the rear spinner bulkhead or build up the front spinner plate - I'm concerned about balance. Thanks for your thoughts....

Doug

 

[GEM930]

I have the same problem. Is there a larger bulkheah avalable? I considered using a spacer to push the bulkhead further forward (to reach a smaller diameter section of the cone, but I am also concerned about balance issues. Anyone????

 

[DanH]

Guys, the S603 is for the Vans glass spinner. No surprise if it doesn't work with a substitute spinner. In my opinion you need a front bulkhead. Find or fabricate a good one. There is no balance issue if the fabricated bulkhead is fully symmetrical and true on center.