John Brunke
Member
Dear Builders,
On the gear leg instructions Van's talks about using a stick "between the ground and the horizontal stabilizer". While they would usually go into the dimensions of such an item, here it just refers to a stick. While I get the intent of what they are trying to measure, I am having a hard time visualizing how this stick gets attached to the flat surface of the horizontal stabilizer. It would seem like you need several people to hold all these strings. I'm obviously missing something.
I did a search on this and did not find this particular item mentioned. Would any of you have a photo of how you did this alignment? It would be greatly appreciated.
John Brunke
RV7 QB in slow build mode.
On the gear leg instructions Van's talks about using a stick "between the ground and the horizontal stabilizer". While they would usually go into the dimensions of such an item, here it just refers to a stick. While I get the intent of what they are trying to measure, I am having a hard time visualizing how this stick gets attached to the flat surface of the horizontal stabilizer. It would seem like you need several people to hold all these strings. I'm obviously missing something.
I did a search on this and did not find this particular item mentioned. Would any of you have a photo of how you did this alignment? It would be greatly appreciated.
John Brunke
RV7 QB in slow build mode.