Lets try this again. Having trouble attaching the right picture.
This picture shows a piece of plywood with a one and 7/16 inch radius holding my air ramp in a position according to plans page 36. Obviously, this does not put the flange in a position to rivet it to the firewall. Does the builder bend this radius further to put the flange in a position flat against the firewall? Is there a prescribed dimension for the flange to fall against the firewall that I am missing?
http://i59.tinypic.com/6seupx.jpg
This picture shows a piece of plywood with a one and 7/16 inch radius holding my air ramp in a position according to plans page 36. Obviously, this does not put the flange in a position to rivet it to the firewall. Does the builder bend this radius further to put the flange in a position flat against the firewall? Is there a prescribed dimension for the flange to fall against the firewall that I am missing?
http://i59.tinypic.com/6seupx.jpg