guidoism
Member
I don't understand my air compressor's regulator ? When I set the output pressure to something lower, like 40, it will initially shoot out at 40, but within seconds the output pressure will fall to close to zero. If I modify the output pressure while continuously using it then when I stop using the air it will creep up to something like 100. Then when I use it again it will initially start out at 100 and then quickly drop down to the 40 which I initially wanted.
What's going on here? Is this how it's supposed to work?
I can make it work with my rivet gun if I'm careful, but it's certainly not ideal. Are there ways around this? I also have a brass inline regulator on my rivet gun but I don't understand it yet. Too many variables. Ugh.
What's going on here? Is this how it's supposed to work?
I can make it work with my rivet gun if I'm careful, but it's certainly not ideal. Are there ways around this? I also have a brass inline regulator on my rivet gun but I don't understand it yet. Too many variables. Ugh.