[Stockmanreef]

Before I move ahead I just want to make sure that I am doing this correctly. It says to mating counter sink the trailing edge. At this point, I think that is the the wedge shaped part and not the trailing edge skin. I assume that the "trailing edge" gets countersunk, then the trailing edge of the skin gets dimpled.

I have already counter sunk the wedge piece. Before I dimple the trailing edge of the skin, I wanted to make sure.

Maybe this is clear in the plans, but IMO it is not crystal clear.

Thanks
Ken

 

[YellowJacket RV9]

Yes you are correct, dimple the skins and countersink the wedge, assuming it is like all other Vans models with the wedge. The skin is way too thin to countersink.

Chris

 

[Stockmanreef]

thanks. I assumed that was the case, but wanted to make sure