skyking902001
Well Known Member
I am ready to rivet W-414 aileron bracket to rear spar on a RV-8 QB wing. In looking at the back side of the rear spar, it appears that the shop head of the rivets will overlap onto the rib flange. If I place the manufactured head on the back side of the rear spar, the head fits flush, but the rivet set will not fit over the head without contacting the rib flange. I looked at the other wing and it will have the same issue. Suggestions?? Thanks in advance.
Skyking902001
RV-8 QB
Skyking902001
RV-8 QB