Airflow Performance FM-200 Adapter on Sump - Is this normal?
Yesterday I got my engine hung - much easier than I thought it would be.
As I was admiring all the shiny bits, I noticed the fit of the Airflow Performance adapter plate to the sump. There is quite a mismatch in the diameter of the bore of the adapter plate and the inlet bore in the sump. The adapter plate measures approx. 2.375 and the bore in the sump is approx. 1.95. So, I'm questioning if this is normal. It sure goes against all my hotroding instincts, but maybe it's OK. The engine is a TMX-IO-360 and the injector servo is a FM-200.
Here's a couple of pictures:
Close up:
Any thoughts??
Thanks - Chris
Yesterday I got my engine hung - much easier than I thought it would be.
As I was admiring all the shiny bits, I noticed the fit of the Airflow Performance adapter plate to the sump. There is quite a mismatch in the diameter of the bore of the adapter plate and the inlet bore in the sump. The adapter plate measures approx. 2.375 and the bore in the sump is approx. 1.95. So, I'm questioning if this is normal. It sure goes against all my hotroding instincts, but maybe it's OK. The engine is a TMX-IO-360 and the injector servo is a FM-200.
Here's a couple of pictures:
Close up:
Any thoughts??
Thanks - Chris
Last edited: