[idleup]

In the manual for AeroLED it states that the peak load is 2.4A for each strobe. The duration of the this load is quite short 0.33 seconds. The wiring for each strobe is 20AWG(Shielded). What size fuse should I use to protect these three strobes? If I add up those three loads it is 7.2A so I thought maybe a 10A fuse. But since the duration of the load is so short I am wondering if I am putting too large of a fuse...

Anyone else with this setup could you please advise?

Thanks,

 

[Dbro172]

Read the current instructions

http://www.aeroleds.com/LinkClick.aspx?fileticket=VgPG5vCTuB4=&tabid=6270&mid=13206

The directions here, right on the wiring diagram..... Budget 3A per strobe and use a 7A or 10a breaker (presumably for two vs. three strobes.)

 

[idleup]

Thanks Derek, that is what I needed.