Not trying to be snarky, but per the AFS wiring diagrams.
The ACM allows for a lot of functionality, but as is always the case you'll probably want to do something out the ACM's number of supported circuits. Then you'll need to add a bus and some kind of current protection.
I haven't wired them yet but have drawn the schematics. Plannis to run a bus accross all the switches. Bus wire routes to the FOT. Other side of each switch is wired per ACM plans to pins on the harness.
I did add one protected circuit from the Master to two breakers then the P-Mag switches. AFS recommended.
The problem with the ACM diagrams is twofold:
1) The diagram shows wiring for their Switch Panels
2) The switches are not power switches but logic switches which is confusing to me.
Thanks though
Larry, any chance you could upload or pm the schematics to me?