QuixoteAg Well Known Member Patron Oct 12, 2020 #1 Vans instructions on the kit apparently say for 7's up through 14's and NOT for others....confused why it wouldn't work on a 6 or at least the concept if maybe not the exact dimensions of their kit. anybody do this with their 6?
Vans instructions on the kit apparently say for 7's up through 14's and NOT for others....confused why it wouldn't work on a 6 or at least the concept if maybe not the exact dimensions of their kit. anybody do this with their 6?
gyoung Well Known Member Oct 12, 2020 #2 Yup, did it on mine. You just have to locate it yourself. Works great and huge access improvement.
E Ethanol1 Well Known Member Oct 12, 2020 #4 access covers Look at the RV6 on the home page. Two covers.
gyoung Well Known Member Oct 12, 2020 #5 I used their kit. It's a no brainer. You couldn't buy all the hardware for the cost and saves hours compared to rolling your own. I just cut off the locating tabs since our rivets aren't in a defined location like the -7.
I used their kit. It's a no brainer. You couldn't buy all the hardware for the cost and saves hours compared to rolling your own. I just cut off the locating tabs since our rivets aren't in a defined location like the -7.
2 219PB Well Known Member Oct 13, 2020 #6 I made my own from carbon fiber. Was a fun project. If I had to do it over again I would have done the pilot's side as well.
I made my own from carbon fiber. Was a fun project. If I had to do it over again I would have done the pilot's side as well.
QuixoteAg Well Known Member Patron Oct 13, 2020 #7 219PB said: I made my own from carbon fiber. Was a fun project. If I had to do it over again I would have done the pilot's side as well. Click to expand... That's beautiful work.
219PB said: I made my own from carbon fiber. Was a fun project. If I had to do it over again I would have done the pilot's side as well. Click to expand... That's beautiful work.