Charles in SC
Well Known Member
Today I drilled the firewall holes out for my motor mt and I am looking at fitting the front gear ( mine is a tail wheel) It looks like I will have to grind out a couple of notches in the bottom corners of the firewall flange for the gear legs to clear. Is that correct? The plans do not say anything about this and I want to be sure I have not missed something.
I am also ready to start marking and cutting the canopy, as far as the marking goes is a sharpie the thing to use and if so what is the best way to clean the marks off when finished? I do not think I should use the solvents that I use on the aluminum.
Thanks for any input!
I am also ready to start marking and cutting the canopy, as far as the marking goes is a sharpie the thing to use and if so what is the best way to clean the marks off when finished? I do not think I should use the solvents that I use on the aluminum.
Thanks for any input!