Simon Hitchen
Well Known Member
I've read as many posts as I can find so I'm asking for some help.
I'm flying an 8 that is rock solid to wheel land but as I transition to three point or land three point it gets a little squirely. Nothing unmanageable bit since I've got the wheel pants off I thought I'd measure the alignment.
The measurements were taken with half fuel, pilot in the front, the tail on the ground and grease plates under both main wheels.
I've ordered a few 1/2 degree shims from van's. What do you guys with experience think I should do with regards to shimming.
Many thanks.
I'm flying an 8 that is rock solid to wheel land but as I transition to three point or land three point it gets a little squirely. Nothing unmanageable bit since I've got the wheel pants off I thought I'd measure the alignment.
The measurements were taken with half fuel, pilot in the front, the tail on the ground and grease plates under both main wheels.
I've ordered a few 1/2 degree shims from van's. What do you guys with experience think I should do with regards to shimming.
![IMG_1780.jpg](/community/proxy.php?image=https%3A%2F%2Fs14.postimg.org%2Ft5kb1rmq9%2FIMG_1780.jpg&hash=b96edf7002fc3427c9f29adbd94918d4)
Many thanks.