[N941WR]

This question is for -7's, not -7A's. Sorry guys.

How did you attach the upper gear leg fairings and where?

I was unable to find a picture of the platenuts and their location.

 

[Rene Bubberman]

Hi Bill,

I used two platenuts in the bottom of the fuse and one in the cowl for each fairing. They are all out of sight and the fit is very good.
A bit of it can be seen on http://websites.expercraft.com/PHVII/index.php?q=log_entry&log_id=10574

 

[N941WR]

Rene,

Thanks for the tip.

I elected to drill and tap a hole for a #6 screw along the side stiffener and then another #6 plate nut on the side and bottom of the cowling.

 

[Gordon Henry]

upper gear leg intersection fairing RV-7

I elected to bond the intersection fairing to the fuselage and the bottom engine cowling. I then carefully cut the fairing between cowl and fuselage. Looks great, but it seems the bottom cowling is a bit difficult to get back on when removed. May just take a little practice. Would likely go more smoothly with a person on each side. I'll get it down pat before I paint. If you do this be sure to get the screw for the gear leg fairing hose clamp under the engine cowl portion or you'll be unable to remove the gear fairing.