alpinelakespilot2000
Well Known Member
Any suggestions on when to rivet the F-704K side bulkhead covers? (They are the ones that are pop-riveted and cover the space between the anodized side bulkheads at the center section.) I can't see when the instructions say to do so, and am wondering if I need to wait until the wings are on for good to make access (at least visually) to the spar bolts easier. I would just wait until then but the manner in which I'm reinforcing my arm rests prevents riveting the arm rests until those covers are on for good.
Also, I'm planning to put an eyeball light on each cover aimed at the instrument panel. Any suggestions on how high and/or whether this is a good place to put them on a slider? Also, I'm planning to drill a hole and then just leave some string in there to pull the lighting wire through later. Good plan?
Thanks.
Also, I'm planning to put an eyeball light on each cover aimed at the instrument panel. Any suggestions on how high and/or whether this is a good place to put them on a slider? Also, I'm planning to drill a hole and then just leave some string in there to pull the lighting wire through later. Good plan?
Thanks.